Linux中国  设为主页
 收藏本站
 
当前位置: > 首页 ->网络应用 ->网络工程 ->设备攻略:路由器日常维护和故障诊断
  相关分类: 
Firefox专题
服务器
搜索引擎优化SEO
网管天地
网络安全
网络工程
网络技术
无线技术
邮件服务器
  站内搜索: 
热门文章排行
热门文章排行 企业综合布线系统工程设计参考大全 (04-25)
组网基础:机房内网络设备布局设计((04-25)
网络工程师必须懂的十四大专业术语 (04-25)
IT公司机房内网络设备布局设计实例 (04-25)
设备攻略:路由器日常维护和故障诊断(04-25)
精采文章排行
精采文章排行 设备攻略:路由器日常维护和故障诊断(04-25)
中创软件InforGuard安全防范应用方案(04-25)
轩辕网络在培正商学院第二期网络工程(04-25)
在大型IP网络中采用MPLS实现流量工程(04-25)
组网基础:机房内网络设备布局设计 (04-25)
  ·中创软件InforGuard安全防范应用方案 ·轩辕网络在培正商学院第二期网络工程 ·在大型IP网络中采用MPLS实现流量工程 ·组网基础:机房内网络设备布局设计 ·访问控制—保护核心设备中的核心资源 ·建筑安装工程公司财务系统服务器案例 ·IPv6促中国成为网络设备商的发展沃土 ·485布线工程中应注意的几个问题 ·网络工程师必须懂的十四大专业术语

设备攻略:路由器日常维护和故障诊断

作者:Webmaster   来源:51CTO    点击:   日期:2007-04-25 [收藏] [投稿]

  IE是否经常中毒?推荐您

通常我们使用show interface命令来查看接口的信息,如show interface gig 1/0或者show int pos 2/0等来分别查看路由器上千兆以太接口和POS接口的端口信息。

  查看以太网接口信息,在7507上使用命令为:  show interfaces fastethernet [slot/port-adapter/port]

  查看POS接口信息,在7507上使用命令为:   show interfaces pos [slot/port-adapter/port]

  1、下例给出了在7507上查看第1槽位上第1个PA上的第1个快速以太网接口的接口配置信息:

Router# show interfaces fastethernet 1/0/0

Fast Ethernet1/0/0 is up, line protocol is up

Hardware is TSWITCH, address is 00e0.f7a4.5130 (bia 00e0.f7a4.5130)

MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, rely 255/255, load 1/255

Encapsulation ARPA, loopback not set, keepalive set (10 sec)

Half-duplex, 100BaseTX

ARP type: ARPA, ARP Timeout 04:00:00

Last input 00:05:30, output 00:00:00, output hang never

Last clearing of "show interface" counters never

Queueing strategy: fifo

Output queue 0/40, 0 drops; input queue 0/75, 0 drops

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

312 packets input, 18370 bytes, 0 no buffer

Received 216 broadcasts, 0 runts, 0 giants, 0 throttles

3 input errors, 0 CRC, 0 frame, 0 overrun, 3 ignored, 0 abort

0 input packets with dribble condition detected

15490 packets output, 1555780 bytes, 0 underruns

2 output errors, 0 collisions, 2 interface resets

0 babbles, 0 late collision, 0 deferred

0 lost carrier, 0 no carrier

2 output buffer failures, 0 output buffers swapped out


  2、下例给出了在7507上查看第2槽位上第1个PA上的第1个快速以太网接口的接口配置信息:

Router# show interfaces pos 2/0/0

POS2/0/0 is up, line protocol is up

Hardware is cyBus Packet over Sonet

Description: PRI-T1 net to zippy (4K) to Pac-Bell

Internet address is 10.1.1.1/27

MTU 4470 bytes, BW 1000 Kbit, DLY 40000 usec, rely 255/255, load 1/255

Encapsulation HDLC, loopback not set, keepalive set (3 sec)

Last input 00:00:00, output 00:00:00, output hang never

Last clearing of "show interface" counters 00:23:09

Queueing strategy: fifo

Output queue 0/40, 0 drops; input queue 0/75, 0 drops

5 minute input rate 0 bits/sec, 1 packets/sec

5 minute output rate 1000 bits/sec, 1 packets/sec

1046 packets input, 54437 bytes, 0 no buffer

Received 485 broadcasts, 0 runts, 0 giants, 0 parity

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

4013 packets output, 1357412 bytes, 0 underruns

0 output errors, 0 applique, 0 interface resets

0 output buffer failures, 0 output buffers swapped out

0 carrier transitions



 如果您对本文有任何疑问或者建议,请到讨论区发表您的意见: >> 论坛入口 <<



上一篇:中创软件InforGuard安全防范应用方案   下一篇:没有了
文章评论】 【收藏本文】 【推荐好友】 【打印本文】 【我要投稿】 【论坛讨论

   相关文章:
·设备攻略:路由器日常维护和故障诊断

   文章评论:(1条)
  
 请留名: 匿名评论   点击查看所有评论 论坛讨论
 

 声明:刊登此文章是为了传递更多信息,文章内容仅供参考,转载请注明出处。